Panasonic DMC-LZ7 - Manual (Page 15)

Preparation
15
VQT1C60
Setting Date/Time
(Clock Set)
∫ Initial setting
The clock is not set, so the following screen
appears when you turn the camera on.
A: [MENU/SET] button
B: Cursor buttons
1 Press [MENU/SET].
2 Press 3 4 2 1 to select the
date and time.
A: Time at the home area
B: Time at the travel destination (P53)
•
2/1: Select the desired item .
• 3/4: Set the display order for the date
and time.
• : Cancel without setting the clock.
3 Press [MENU/SET] to set.
• Turn the camera off after setting the
clock. Then set the mode dial to a
recording mode to turn the camera on
and check whether or not the clock
setting is correct.
∫ Changing the clock setting
1 Press [MENU/SET].
2 Press
3/4 to select [CLOCK SET].
(P63)
3 Press 1 and then perform steps 2 and
3 to set the clock.
4 Press [MENU/SET] to close the menu.
• You can also set the clock in the
[SETUP] menu. (P18)
• When batteries have been inserted for
more than 3 hours, the clock setting is
stored in the camera for approximately
3 months even if the batteries are
removed.
• You can set the year from 2000 to 2099.
The 24-hour system is used.
• If the clock is not set, the correct date
cannot be printed when you stamp the
date on the pictures with [DATE STAMP]
(P71) or order a photo studio to print the
pictures. (P74)
PLEASE SET THE CLOCK
CLOCK SET MENU
D/M/Y
JAN 1 1 2007 . . 0 0 00 :
CLOCK SET
:
:
SELECT SET EXIT MENU
CANCEL
VQT1C60ENG.book 15 ページ ２００７年１月１１日 木曜日 午後６時４９分