Pella Impervia 80YW0102 - Manual (Page 11)

The exposed wood and flashing tape on the exterior stop
needs to be covered/protected. There are many ways to
accomplish this, and each case can be unique.
$IHZSRVVLELOLWLHVLQFOXGH
D &RYHULQJWKHH[LVWLQJWULPZLWKDOXPLQXPFRLOZUDS
frame expander.
E 6DQGLQJSULPLQJDQGSDLQWLQJWRPDWFKH[LVWLQJWULP
F &RYHULQJWKHH[SRVHGZRRGZLWKDKLJKTXDOLW\H[WHULRU
grade sealant.
Note: The contractor/installer will determine how to
finish the exterior.
EXTERIOR FINISH OF EXISTING FRAME
&95&3*030'8*/%08
8*5)'3".&&91"/%&3
INSTALLING ROTO COVER AND CRANK
A. Place the cover over the operator stud and snap
into place.
B. Apply pressure to the pocket end of the cover and
snap into place.
1PDLFU&OE
0QFSBUPS4UVE
#
"
AWNING AND CASEMENT ONLY
"8/*/(
$"4&.&/5
,OPC
1PDLFU
&
$SBOL)BOEMF
0QFSBUPS4UVE
4FU4DSFX
%
$
& 8VHDPHGLXPVL]HŶDWEODGHVFUHZGULYHUWR
loosen the set screw in the crank handle.
' 6OLGHWKHFUDQNKDQGOHRQWRWKHVWXG8QORFN
open window, then close and lock window.
E. Fold the crank handle down and check alignment
of knob with the pocket.
Note: You may need to adjust the crank position
on the stud until the correct alignment is achieved.
F. Open the crank and tighten the set screw.
G. After the final installation, fold the crank over
and snap the knob into the pocket.
Note: Even with the window open the crank
can be folded to avoid interfering with the
window treatments.