Pella 80GY0102 User Manual

Pella For Home

Part Number: 80GY0102

Always read the Pella

Limited Warranty before purchasing or installing Pella products. By installing

this product, you are acknowledging that this Limited Warranty is part of the terms of the sale.
Failure to comply with all Pella installation and maintenance instructions may void your Pella
product warranty. See Limited Warranty for complete details at http://www.pella.com.

INSTALLATION INSTRUCTIONS - INSTRUCCIONES DE INSTALACION

FOR HURRICANESHIELD

IMPACT-RESISTANT

CASEMENT AND AWNING WINDOWS IN WOOD FRAME CONSTRUCTION

These instructions were tested and are Dade County certiﬁed for single laminated glass and ASTM
(Hallmark) certiﬁed for laminated insulating glass.

$PSOFS

'MBTIJOH

5BQF

5PQ'MBTIJOH5BQFT

$PSOFS

'MBTIJOH

5BQF

'JO

$PSOFS

/BJMJOH'JO

8JOEPX#PUUPN

4JEF

'MBTIJOH

5BQF

4JEF

'MBTIJOH

5BQF

4JMM'MBTIJOH5BQF

8BUFS3FTJTUJWF#BSSJFS

4IFBUIJOH

'SBNJOH

Important Safety Information:
Pella® HurricaneShield

products have been tested in accordance with the large missile impact

testing requirements of ASTM E 1886 and ASTM E 1996. Pella HurricaneShield products are
neither hurricane proof nor are they shatter proof. Severe wind and rain may produce temporary
conditions which exceed product performance standards. When these units are subjected to intense
storms or extreme conditions, which exceed the intended design pressures, air, water and ﬂying debris
inﬁltration may occur. The performance of any building is dependent upon the design, installation,
and workmanship of the entire building system. Pella Corporation strongly recommends consulting
an experienced architect, contractor, or structural engineer prior to installation of Pella products.

The individual (building owner, architect, contractor, installer and/or consumer) responsible for the
project must take into account local conditions, building codes, inherent component limitations,
the effects of aging and weathering on building components, and other design issues relevant to each
project. The determination of the suitability of all building components for each project, as well
as the design and installation of ﬂashing and sealing systems, are the responsibility of the building
owner, architect, contractor, installer and/or consumer.