Panasonic CF-VDW07BH - Manual (Page 18)

18
E
Connector
Latch
Tab
1
Slide the latch to the right, and open the cover, then in-
sert the battery pack in the wireless display. After in-
serting the battery pack, close the cover, then slide the
latch to the left.
Setup the Wireless Display
First-time Operation
Limitation when using the serial port
When the wireless display is not connected to the computer, the serial port of the wireless
display cannot be used.
There are some serial devices and applications that will not work. This is because the
serial port of the wireless display operates through a virtual serial port.
• Devices or device drivers that start up and carry out port operation confirmation before
connection establishment of the wireless display
For example: Serial mouse devices
• Non-virtual port applications
For example: MS-DOS applications
When a device driver is not automatically installed, follow the instructions of the opera-
tions manual included with the device (e.g., insert a disc and install the driver).
Match the COM port number to the number that is displayed in [WDSP COM Port (COMx)]
with the following procedure. For example, if [WDSP COM Port (COM6)] is displayed,
set the serial port to [COM6].
Windows XP
[start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -
[Device Manager] - [Ports (COM & LPT)]
Windows 2000
[Start] - [Settings] - [Control Panel] - [System] - [Hardware] - [Device Manager] -
[Ports (COM & LPT)]
Be sure to insert the battery pack as illustrated.
CAUTION