Bosch BSN1 - Manual (Page 13)

8
de
Maintenance
Ⅲ Before the appliance is cleaned, ensure that it
has been switched off and the mains plug
removed.
Ⅲ Vacuum cleaners and accessories made of
plastic can be cleaned using a general
commercial plastic cleaner.
! Do not use scouring agents, glass or
all-purpose cleaners.
Never immerse the vacuum cleaner in water!
Ⅲ If necessary, the dust section can be cleaned
using another vacuum cleaner, or simply
cleaned out using a dry dust cloth / dust
brush.
Subject to technical change without notice.
Illustration 20
Insert he new dust bag in the holding fixture
up until the stop.
Illustration 21
When closing the lid, ensure that both of the
locking keys on the lid fit properly into the
recesses on the underside of the appliance.
After closing the cover, this audibly clicks into
place when pushed in the direction of the
arrow.
! After vacuuming fine dust particles (like for
example, plaster, cement etc.), clean the
motor filter and, if necessary, replace the
microfilter.
Changing the microfilter
When should I change the filter? Each time a
new paper filter pack is fitted.
Illustration 22
Ⅲ Take off the covering by pushing the locking
key in the direction of the arrow.
Ⅲ Remove the microfilter.
Ⅲ Push the new microfilter on to the retaining
key of the covering - text can be seen.
Ⅲ Close the covering.
Cleaning the motor filter
Illustration 23
Ⅲ Open the cover.
Ⅲ Unlock and open the filter holder by pressing
in the direction of the arrow.
Illustration 24
Remove the motor protection filter and shake
Illustration 25
Ⅲ Place the motor protection filter in the filter
holder
Ⅲ Close the filter holder and engage
Ⅲ Close the cover
en
Innenteil 194 443 B 19.10.2006 16:51 Uhr Seite 8