Petsafe IN-GROUND FENCE PIG00-10773 - Manual (Page 33)

www.petsafe.net 33
Wire Break Location Test
Please follow these steps in determining where you have a break in your Boundary Wire:
1. Locate your original splice(s) and verify they have a good, solid connection.
2. Check your yard to determine any possible damage to the Boundary Wire (e.g. recent
digging, aerating, rodent burrowing, or any other noticeable disturbance in your yard
next to the Boundary Wire).
If you still cannot find the break in the Boundary Wire, there are two options for locating it:
Option 1: Contact the Customer Care Center to purchase a Wire Break Locator that will
locate the break in the Boundary Wire.
Option 2: Follow the procedure below:
1. Unplug the Fence Transmitter.
2. Connect both ends of your twisted Boundary Wire to one Loop Wire Terminal.
3. Measure and cut a Test Wire which is half the length of your total Boundary Wire
footage.
4. Connect one end of Test Wire to the other Loop Wire Terminal.
5. Locate the halfway point of your boundary and cut the Boundary Wire.
6. Splice the other end of the Test Wire to either side of your Boundary Wire where you
cut it in half.
7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop
Indicator Light glows solid green, you can assume the break is in the other half of the
Boundary Wire.
8. If the Loop Indicator Light is off and the alarm sounds, you may assume there is a break
in this portion of the Boundary Wire. However, there is a small chance of having more
than one break in your system. Be sure to check both halves of your entire loop.
9. Replace the damaged Boundary Wire with new Boundary Wire.
10. Reconnect the Boundary Wire to the Fence Transmitter.
11. Check the Loop Indicator Light. If the Loop Indicator Light glows solid green, test the
system with the Receiver Collar.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification
of the terms, conditions and notices contained herein. Usage of this Product implies
acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific
temperament of your pet may not work with this Product. If you are unsure whether
this is appropriate for your pet, please consult your veterinarian or certified trainer.
Proper use includes reviewing the entire Guide provided with your Product and any
specific Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended
to harm, injure or provoke. Using this Product in a way that is not intended could result in
violation of Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems ® Corporation be liable for any direct, indirect, punitive,
incidental, special or consequential damages, or any damages whatsoever arising out of
or connected with the use or misuse of this Product. Buyer assumes all risks and liability
from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems ® Corporation reserves the right to change the terms, conditions and
notices under which this Product is offered.