Petsafe IN-GROUND FENCE PIG00-10773 - Manual (Page 20)

20 Customer Care Center 1-800-732-2677
Install the Boundary Wire
Before you begin installing the Boundary Wire, unplug the Fence
Transmitter power adapter from the Surge Protector or outlet.
To Bury the Boundary Wire
Burying the Boundary Wire is recommended to protect it and prevent disabling
the system.
1. Cut a trench 1-3 inches deep along your planned boundary.
2. Place the Boundary Wire into the trench maintaining some slack to allow it
to expand and contract with temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire
into the trench. Be careful not to damage the Boundary Wire insulation.
To Attach the Boundary Wire to an
Existing Fence
The Boundary Wire of the PetSafe ® Elite Little Dog In-Ground Fence ™ can be
attached to a chain link fence, split rail fence, or a wooden privacy fence. The
Boundary Wire can be attached as high as needed. However, make sure the
Boundary Width is set at a high enough range for the pet to receive the signal.
If using a Double Loop with an existing fence at least five feet tall, run the
Boundary Wire on top of the fence and return it on the bottom of the fence to
get the five foot separation needed.
• Chain Link Fence (7A):
Weave Boundary Wire
through the links or use
plastic quick ties.
• Wooden Split Rail or
Privacy Fence (7A):
Use staples to attach
Boundary Wire. Avoid
puncturing the insulation
of the Boundary Wire.
• Double Loop with an
Existing Fence: Run
Boundary Wire on top
of the fence and return
STAPLE WIRE TO FENCE
WEAVE WIRE INTO FENCE
STAPLE WIRE
TO FENCE
7A
5' 5'
SINGLE LOOP
DOUBLE LOOP
7B
it on the bottom of the fence to get the 5 foot separation needed.
• Gate (Single Loop) (7B): Bury the Boundary Wire in the ground across the gate
opening. Note: The signal is still active across the gate. Your pet cannot pass
through an open gate.
• Gate (Double Loop) (7B): Bury both Boundary Wires across the gate opening
while keeping them at least 5 feet apart.
Step
7