Petsafe IN-GROUND FENCE PIG00-10773 - Manual (Page 23)

www.petsafe.net 23
4. The Receiver Collar should fit snugly, yet loose
enough to allow one finger to fit between a
contact point and your pet’s neck (9B). Allow
your pet to wear the collar for several minutes,
then re-check the fit. Check the fit again as
your pet becomes more comfortable with the
Receiver Collar.
5. Once you are satisfied with the fit of the
Receiver Collar then you may trim any excess
collar strap as follows (9C):
a. Mark the desired length of the Receiver
Collar with a pen. Allow for growth if your
pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet
and cut off the excess.
c. Before placing the Receiver Collar back onto
your pet, seal the edge of the cut collar by
applying a flame along the
frayed edge.
9B
9C
To Re-Thread the Collar
Slide Buckle
Ridges
The slide buckle prevents the collar from
becoming loose around your pet’s neck.
The ridges must be facing up; the collar will slip if
it is not properly threaded.