Petsafe IN-GROUND FENCE PIG00-10773 - Manual (Page 14)

14 Customer Care Center 1-800-732-2677
1. Turn the power OFF to the
outlet that the Surge Protector
and Fence Transmitter will be
plugged into.
2. We recommend that, if
possible, use the outlet center
screw that holds the cover
plate in place to secure the
Surge Protector to the outlet.
To do this, tape the top of
the cover plate to the wall,
then remove the cover plate
center screw. Plug the Surge
Protector into the lower outlet
Fence Transmitter
Power
Adapter
Red Loop Tabs
Boundary Wires
(Twisted)
Boundary
Wire
Terminals
Transmitter
Wires
(Twisted)
Boundary Wire
Loop
Black
Transmitter
Tabs
LP-4100
Power
Jack
Transmitter
Loop
4A
and then secure the cover plate using the longer screw included with the protector.
The screw is for mechanical attachment only and does not ground the protector.
Remove the tape and turn ON the power to the outlet.
3. Run the Boundary Wire through a window, under a door,
through a crawl space vent, or any other appropriate available
access. You can also drill a hole through your wall.
4. Strip 3 ⁄
8
inch of insulation from the ends of the Boundary Wire.
Insert the stripped ends into the 2 left red connector holes on
the bottom of the Surge Protector labeled “Loop” (4B). There
should be 1 wire in each connector hole. Press the plastic tab,
insert the wires and release the tab. Make sure the wires do
not touch each other at the terminals.
Verify that the boundary loop and transmitter wires
connect to the proper Surge Protector terminals.
Reversed connections will result in an increased risk
of surge related damage.
LOOP TRAN
SMITTER
Push Tab
Down
Insert bare end
of wire into
opened slot
and release tab
to lock.
4B
5. Determine the length of wire needed to pass from the Surge Protector to the Fence
Transmitter. Measure and cut 2 lengths of wire, then strip 3 ⁄
8
inch of insulation at both
ends. Twist the 2 lengths together, with at least 10-12 twists per foot, so the wires will
not send out a signal.
6. Insert the ends of the the twisted transmitter wires into the right 2 black connectors at
the bottom of the Surge Protector labeled “Transmitter”.
7. Press the red plastic tabs on the Fence Transmitter and insert the opposite ends of the
twisted wire into the Boundary Wire Terminals.
8. Turn the Boundary Width Control knob to 10. This will set the Boundary Width at the
maximum width.
9. Plug in the transmitter power adapter to the outlet on the front of the Surge Protector.
10. The Power Light and Loop Indicator Lights should come on. If this does not happen,
see the “Troubleshooting” section.
For added protection, when unused for long periods of time or prior to
thunderstorms, unplug from the wall outlet and disconnect the loop boundary
wires. This will prevent damage to the transmitter due to surges.