Cli commands to set up subnet roaming – Polycom A800 User Manual
Page 28
Configuration Guide
PN: 1725-36080-001_J.doc
28
CLI Commands to Set Up Subnet Roaming
Commands for the master switch (the Aruba 800)
Configure terminal
ip
default-gateway
ap location 1.1.0 (#ap connected to 800)
lms-ip
ap location 1.2.0
lms-ip
ip route 224.0.0.0 255.0.0.0
gateway>
exit
write
mem
Commands for the local switch (the Aruba 6000)
The AP’s IP address must be on the same subnet as the switch.
Configure terminal
masterip
interface loopback
ip address
vlan
1
interface vlan 1
ip
address
interface fastethernet
switchport access vlan 1
(only if the port is an
access
port)
trusted
no
shut
!
ip
default-gateway
!
exit
write
mem
After the master switch IP address and the local switch IP address are
configured on the local switch, the switch needs to be rebooted prior
to use.