PACKARD BELL MH4000 - Manual (Page 70)

4-18
Configuring Your System
Using the SCSISelect Utility
To run the SCSISelect Utility, perform the following
procedure:
1. Power-on the system. The system boots up.
2. During initialization, press CONTROL +A. The
SCSISelect Utility starts. When SCSISelect detects
more than one AIC-78xx host adaptors, it displays a
selection menu listing the bus and device number of
each adapter. When the selection menu appears,
select the channel you wish to configure as follows:
Bus : Device Selected SCSI Adapter
00 : 08h AIC7880
01 : 06h AIC7860
3. Once you select the adapter, the following screen is
displayed:
SCREEN DESCRIPTION
Configure/View Host Adapter
Settings Configure host adapter
and device settings.
SCSI Disk Utilities The utility scans the SCSI
bus for SCSI devices,
reports a description of
each device. Run these
utilities before configuring
SCSI devices.
4. If you wish to format a disk, verify disk media,
or display a list of devices and their SCSI IDs,
select “SCSI Disk Utilities”. If you wish to
configure the adapter or a device, select
“Configure/View Host Adapter Settings”.