PACKARD BELL MH4000 - Manual (Page 58)

4-6
Configuring Your System
SCU Configuration Settings
Table 4-3 shows the recommended settings for the SCU
and provides a place for you to record any changes you
make to these settings. To view and/or change SCU
Configuration settings, select Step 3 under the System
Configuration Utility Menu. Once you have selected
step 3, you can press the F7 key to display further
server specifications.
Table 4-3. SCU Configurations
PARAMETER NORMAL SETTING YOUR CONFIGURATION
Flexible Disk Drives
Embedded Controller* Primary**
Flexible Drive A* 1.44 MB (3.5 - inch)
Flexible Drive B* Not Installed
Dual Serial Ports
Serial Port 1* 3F8, IRQ 4**
Serial Port 1* 2F8, IRQ 3**
Parallel Port Configuration
Parallel Port* 378, IRQ 7**
Parallel Port Mode* Bi - directional mode
ESM ASIC IRQ
ESM ASIC IRQ* IRQ13**
Mouse Enabled
SCSI ch0 - PCI SCSI Controller
PCI Function 1* Enabled**
SCSI ch1 - PCI SCSI Controller
PCI Function 1* Enabled**
VGA - PCI VGA Controller
PCI Function 1* Enabled**
Standard VGA Resources Enabled**
* Press ENTER for Menu
** Press F6 to Edit resources