Planar PR Line PR3020 - Manual (Page 43)

DLP® Projector – User’s Manual
Resetting the Lamp
After replacing the lamp, you should reset the lamp hour counter to zero. Refer to the following:
1.
Press the Menu button to open the
Main menu.
2.
Press the cursor button to move
to the Status menu.
3.
Press the cursor button to move
down to Lamp Hour Reset.
4.
Press the cursor or Enter button.
A message screen appears.
5.
Press the cursor buttons in this order:
; ; ; .
The Status menu appears again
showing the Lamp Hours reset to
zero.
Cleaning the Projector
Cleaning the projector to remove dust and grime will help ensure trouble-free operation.
Warning:
1. Be sure to turn off and unplug the projector at least an hour before cleaning. Failure to do so
could result in a severe burn.
2. Use only a dampened cloth when cleaning. Do not allow water to enter the ventilation openings
on the projector.
3. If a little water gets into the projector interior while cleaning, leave unplugged in a well-ventilated
room for several hours before using.
4. If a lot of water gets into the projector interior when cleaning, have the projector serviced.
– 35 –