General, Before reading these instructions, Remote control unit preparation – Panasonic CQ-DFX572U User Manual
Page 5: Battery installation, Power, Source, Pu s h, T e x t
![background image](/manuals/170647/5/background.png)
E
N
G
L
I
S
H
2
CQ-DFX572U
17
General
E
N
G
L
I
S
H
1
CQ-DFX572U
16
Before Reading these Instructions
You can operate this unit by pressing buttons on the main unit and the remote control unit.
∫
These instructions describe buttons that are concerned with operations as follows.
Example: Press [P·SET
"] or [P·SET #]/["] or [#].
∫
Some operations can be activated by pressing buttons only on main unit or remote control unit.
Those cases are described in the instructions.
Example: Press [OPEN] on the main unit.
Battery Installation
1
Remove the battery holder.
Pull the battery holder by the position B while pushing
position A in the direction indicated by the arrow.
2
Install the battery on the battery holder.
Set a new battery properly with its “i” side facing up
as shown in the figure.
3
Insert the battery holder.
Push the battery holder back into its original position.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
≥
Battery type: Panasonic lithium battery (CR2025) (included)
≥
Battery life:
Approximately 6 months with normal use (at room temperature)
≥
Do not disassemble or short the battery. Do not throw a battery into a fire.
≥
Keep batteries away from children to avoid the risk of accidents.
≥
Be careful to observe proper local disposal rules when you dispose of batteries.
Caution:
≥
Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
[buttons on the main unit]/[remote control unit]
Point the remote control unit at the main unit’s sensor.
Remote Control Unit Preparation
Lithium battery
(included)
Back side
Position B
Position A
Battery holder
Note:
≥
When the power is switched on for the
first time, a demonstration message ap-
pears on the display.
To cancel this display, press [DISP] (dis-
play).
ACC
ON
Power
Turn the key in the ignition until the accessory in-
dicator lights.
ON: Press [SRC] (PWR)/[SOURCE] (POWER).
OFF:Press and hold [SRC] (PWR)/[SOURCE]
(POWER) again for more than 1 second.
≥
After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is acti-
vated.
(When security function is set to on
➡
page 40)
1
Source
Press [SRC] (SOURCE)/[SOURCE] to change the source.
2
SRC
DISP
P.SET/DISC
CQ-DFX572U
N 5
O6
W
X
;
/ 1
OPEN
BAND
TUNE
TRACK
PW
R
MU
TE
P
U
S
H
CD RECEIVER WITH CHANGER CONTROL
FOLDER
SET/APM
M
EN
U
VOLUME
SOURCE
T E X T
MOSFET
50W
X
4
6
4
9
7
5
Car Audio
SOURCE
MUTE
POWER
RAND
VOL
3
1
2
DISP
BAND
REP
6
5
SET
SEL
#
SCAN
MENU
NUMBER
8
0
[SOURCE]
(POWER)
[DISP]
(Display)
ST
Radio
CD player
CD changer control
AUX-IN setting
(When a CD is in the player.)
(When a CD changer is
connected and magazine is in
the changer.) ( page 32)
or
MP3 player
(When a MP3 file recorded disc
in the player.) ( page 27)
Remote control signal sensor
§
The brightness of the screen illustra-
tions in this manual is different from
the actual screen brightness.