Set line service – Perle Systems IOLAN CSS User Manual
Page 75
Line Commands 73
Line Commands
Set Line Service
duplex
Specify whether the line is
Full Duplex
(communication both ways at the same time) or
Half Duplex
(communication in one direction at a time).
echo-suppression
This parameter applies only to
EIA-485
Half Duplex
mode. All characters will be
echoed to the user and transmitted across the serial ports. Some EIA-485 applications
require local echo to be enabled in order to monitor the loopback data to determine that
line contention has occurred. If your application cannot handle loopback data, echo
suppression should be
On
. The default is echo suppression
Off
.
speed
Specifies the baud rate of the line; keep in mind that speed is affected by the length of
the cable. You can also specify a custom baud rate; valid values are 50 - 1843200.
Description Sets the service for the line. For services that need further configuration, see
to find the Line Service that you want to configure.
SSL/TLS can be enabled for the following Line Services: DSLogin, Raw, Bidir,
VModem, Server Tunnel, Client Tunnel, Modbus Master, Custom App, and TruePort.
User Level Admin
Syntax
set line .|<number>|* service bidir <config_host> <server_port>
<host_port>
set line .|<number>|* service direct|silent rlogin <config_host>
set line .|<number>|* service direct raw <config_host>
<host_port>
set line .|<number>|* service silent raw <config_host>
<host_port>
[multihost all|backup <config_backup_host> <host_port>|none]
set line .|<number>|* service direct|silent telnet|ssh
<config_host> [<host_port>]
set line .|<number>|* service reverse raw [multihost on|off]|
ssh|telnet <server_port>
set line .|<number>|* service client-tunnel <config_host>
<host_port>
set line .|<number>|* service server-tunnel <server_port>
set line .|<number>|* service dslogin|printer|ppp|slip|udp|
vmodem|modbus-master|modbus-slave|custom-app|power-management
set line .|<number>|* service trueport client-initiated off
[multihost all|backup <config_backup_host> <host_port>|none]
set line .|<number>|* service trueport client-initiated on