Perle Systems IOLAN CSS - Manual (Page 73)

Line Commands 71
Line Commands
stop-bits
Specifies the number of stop bits that follow a byte. The 1.5 option is only available on
the 1-port and 2-port models, but not on the modem of the SDS1M or SDS3M models.
term-type
Specifies the type of terminal connected to the line:
z Dumb
z WYSE60
z VT100
z ANSI
z TVI925
z IBM3151TE
z VT320 (specifically supporting VT320-7)
z HP700 (specifically supporting HP700/44)
z Term1, Term2, Term3 (user-defined terminals)
line-termination
Used with EIA-422 and EIA-485 on SDS 8-port+ IOLAN models, specifies whether or
not the line requires termination. When termination is required, you need to terminate
the line at both ends of the connection.
internet-address
Used with reverse sessions, users can access serial devices connected to the IOLAN by
the specified Internet Address (or host name that can be resolved by a DNS). You must
reboot the IOLAN for the
Internet Address to take affect (the kill line option does not
apply to this parameter). This parameter must be in IPv4 format.