Perle Systems IOLAN CSS - Manual (Page 115)

Network Commands 111
RIP Commands
Set RIP
Show RIP
Description Configures the RIP MD5 key. After pressing Enter, you will be prompted for the MD5
key value.
User Level Admin
Syntax
set rip [authentication none|password|md5]
[ethernet-mode none|send|listen|send-and-listen]
set rip password
set rip md5 <config_md5_id> [end <date> <time>]
[start <date> <time>] [key]
Options authentication
Specify the type of RIP authentication:
z None—No authentication for RIP.
z Password—Simple RIP password authentication.
z MD5—Use MD5 RIP authentication.
ethernet-mode
Enable/disable RIP (Routing Information Protocol) mode for the Ethernet interface with
one of the following options:
z None—Disables RIP over the Ethernet interface.
z Send—Sends RIP over the Ethernet interface.
z Listen—Listens for RIP over the Ethernet interface.
z Send and Listen—Sends RIP and listens for RIP over the Ethernet interface.
password
When you type the set rip password command and press Enter , you will be
prompted to type in a password and then re-enter that password.
< configured_md5_id >
The MD5 identification key.
end < date > < time >
The last day that the MD5 key is valid. Specify as dd/mm/yyyy .
The time that the MD5 key becomes invalid. Specify as hh:mm: [ ss ].
start < date > < time >
The start date that the MD5 key becomes valid. Specify as dd/mm/yyyy .
The time that the MD5 key becomes valid. Specify as hh:mm: [ ss ].
key
When you press Enter after typing the key command, you will be prompted to enter the
MD5 key value and then re-enter the key value.
Description Shows the RIP settings.
User Level Normal, Admin
Syntax
show rip