Perle Systems IOLAN CSS - Manual (Page 74)

Line Commands
72 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Set Line Interface
The SCS and STS IOLAN models only support the EIA-232 interface and therefore does not require
the
interface parameter, instead you can just set the parameters for the EIA-232 interface.
Description Configures line interface (hardware) parameters.
User Level Admin
Syntax
set line .|<number>|* interface eia-232 [monitor-dcd on|off]
[monitor-dsr on|off] [flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|9600|
19200|38400|57600|115200|230400|28800|custom <baud_rate>]
set line .|<number>|* interface eia-422
[flow none|soft|hard|both]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|
custom <baud_rate>]]
set line .|<number>|* interface eia-485-half-duplex
[tx-driver-control auto|rts] [flow none|soft]
[echo-suppression on|off]]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|custom <baud_rate>]
set line .|<number>|* interface eia-485-full-duplex
[tx-driver-control auto|rts] [flow none|soft]
[speed 50|75|110|134|150|200|300|600|1200|1800|2400|4800|
9600|19200|38400|57600|115200|230400|28800|custom <baud_rate>]
Options eia-232 | eia-422 | eia-485-half-duplex|eia-485-full-duplex
Specifies the type of serial line that is being used with the IOLAN. Specify either
EIA-232, EIA-422, EIA-485-half-duplex, or EIA-485-full-duplex. The STS and SCS
models support only EIA-232.
monitor-dcd
Specifies whether the RS-232 signal DCD (Data Carrier Detect) should be monitored.
This is used with modems or any other device that sends a DCD signal. When it is
monitored and the IOLAN detects a DCD signal, the line service is started. Default is
Off . If both Monitor DCD and Monitor DSR are enabled, both signals must be detected
before the line service is started.
monitor-dsr
Specifies whether the RS-232 signal DSR (data set ready) should be monitored. This is
used with modems or any device that sends a DSR signal. When it is monitored and the
IOLAN detects a DSR signal, the line service is started. Default is
Off . If both Monitor
DCD and Monitor DSR are enabled, both signals must be detected before the line
service is started.
flow
Defines whether the data flow is handled by the software ( Soft ), hardware ( Hard ),
Both , or None . If you are using SLIP , set to Hard only. If you are using PPP , set to
either Soft or Hard ( Hard is recommended). If you select Soft with PPP , you must set
the ACCM parameter when you configure PPP for the Line .
tx-driver-control
Used with a EIA-485 serial interface, if your application supports RTS (Request To
Send), select this option. Otherwise, select Auto . Default is Auto .