Perle Systems IOLAN CSS - Manual (Page 49)

Server Commands 49
IPv6 Commands
IPv6 Commands
Set IPv6
Show IPv6
Description Configures the basic IPv6 settings.
User Level Admin
Syntax
set ipv6 [dhcpv6-settings ipv6-address on|off]
[dhcp-settings network-prefix on|off]
[auto-obtain-dns-ipv6 on|off] [eth1|eth2]
[enable-ipv6-addressing on|off] [obtain-using auto-ipv6|dhcpv6]
Options dhcpv6-settings
Determines the types of information that the IOLAN will accept from the DHCPv6
server, IPv6 address(es) and/or network prefix(es).
ivp6-address
When enabled, the IOLAN will accept IPv6 address(es) from the DHCPv6 server. This
is
off by default.
network-prefix
When enabled, the IOLAN will accept the network prefix from the DHCPv6 server.
This is
off by default.
eth1|eth2
Configures the IPv6 settings for the IOLAN’s Ethernet interface 1 and/or Ethernet
interface 2 (SCS models only) connection(s).
enable-ipv6-addressing
When enabled, you can configure the IOLAN to obtain the IPv6 address(es) using IPv6
Autoconfiguration or a DHCPv6 server.
Default: Enabled
obtain-using auto-ipv6|dhcpv6
z auto-ipv6—When enabled, the IOLAN will send out a Router Solicitation
message. If a Router Advertisement message is received, the IOLAN will configure
the IPv6 address(es) and configuration parameters based on the information
contained in the advertisement. If no Router Advertisement message is received,
the IOLAN will attempt to connect to a DHCPv6 server to obtain IPv6 addresses
and other configuration parameters. This is the default.
z dhcpv6—When enabled, requests IPv6 address(es) and configuration information
from the DHCPv6 server.
Description Shows the IPv6 settings.
User Level Admin
Syntax
show ipv6 [eth1|eth2]
Option eth1|eth2
Displays the configuration IPv6 information for the specified Ethernet interface.