Perle Systems IOLAN CSS - Manual (Page 134)

Custom Factory Default
130 IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6
Custom Factory Default
Netload
Set
<filename>
The complete path and file name for the file you are uploading from the IOLAN (this
path should be relative to the default path of your TFTP server, which may or may not
allow drive letters).
Description Transfers a file from a remote host to the IOLAN using the TFTP protocol.
User Level Admin
Syntax
netload factory-default-config <hostname/IP_address> <filename>
Options factory-default-config
Specifies the configuration file that you are going to load from a TFTP server to the
IOLAN that will act as the factory default configuration. See the User Guide for
directions on how to revert back to the original factory default configuration, if
required.
<hostname/IP_address>
The IP address or host name where the file you are downloading to the IOLAN resides.
If you are using a host name, it must be resolved in either the IOLAN’s
Host Table or a
DNS server.
<filename>
The complete path and file name of the file you are downloading to the IOLAN (this
path should be relative to the default path of your TFTP server, which may or may not
allow drive letters).
Description Sets the current configuration on IOLAN to act as the factory default configuration. See
the User Guide for directions on how to revert back to the original factory default
configuration, if required.
User Level Admin
Syntax
set config-to-factory-default