Printronix T5000e - Manual (Page 39)

QUICK SETUP Submenus
39
QUICK SETUP Submenus
Print Intensity
Specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for
each dot. This has a significant effect on print quality. The print
intensity and speed must match the media and ribbon type to obtain
the best possible print quality and barcode grades.
The range is -15 through +15:
• In Transfer mode, the default is -3.
• In Direct Thermal mode, the default is 0.
QUICK SETUP
(cont. from previous page)
SMT: Status
Toolset [1]* Toolset [1] to Toolset [4] SMT: Sel Toolset
Disabled* Enabled
EPC
1
zEPC 2, 3
SMT: Select Tool
Notes:
* = Default.
1 Appears only if Toolset [1] is selected under
SMT: Sel Toolset.
2 Appears only if Toolset [2] is selected under
SMT: Sel Toolset.
3 Undocumented options are reserved for internal
use and future design.
UPCA
1
zUPCA 2, 3
EAN8
1
zEAN8 2, 3
EAN13
1
zEAN13 2, 3
UCC128
1
zUCC128 2, 3
GTIN
1
zGTIN 2, 3