Printronix T5000e - Manual (Page 37)

Positioning The Media Sensors
37
13. Once the sensed distance value and performance is confirmed,
save it to the desired configuration menu as described below
before powering off the printer.
Saving The Configuration
14. Press the key until QUICK SETUP displays.
15. Press
↑ or ↓
until Save Config./1* displays.
16. Press
↵
. Saving Configuration displays briefly.
Run A Barcode Demo Test
IMPORTANT Printronix recommends using the supplied starter roll of 100
labels to set up and verify printer operation. This will avoid
expending the more expensive smart labels for this task.
Before you send an actual print job, run a barcode demo test:
1. Press the PAUSE key until OFFLINE displays.
2. Press TEST PRINT until Printer Tests/Barcode Demo displays.
3. Press ↵. The Barcode Demo test pattern will start and print two
barcodes.
4. Check the test pattern. If necessary, reposition the pressure
blocks to obtain a uniform print quality. In most cases, you will
need to adjust only the right pressure block.
5. If desired, you can run additional printer tests, such as Grey,
Grid, and Checkerboard. See step 1 above to start other tests.
NOTE: These tests run continuously by default. Press
↵ to end the
test.
..
.