Panasonic CX-DH801U - Manual (Page 36)

71
CX-DH801U
44
English
70
CX-DH801U
43
English
Digital audio output
Disc
DVD
Video CD
Sound
recording
format
Optical digital audio output
from connector
Dolby Digital
Dolby Digital bitstream
(1 – 5.1 ch)
DTS*
DTS bitstream (1 – 5.1 ch)
(The analog portion is not out-
put.)
Linear PCM
(44.1/48/88.2/96
kHz 16/20/24 bit) Linear PCM (2 ch)
(44.1/48/88.2/96 kHz
16/20/24 bit)
MPEG 1 MPEG 1 bitstream
Linear PCM
Linear PCM (2 ch)
(44.1 kHz sampling/16 bit)
CD
Linear PCM
Linear PCM (2 ch)
(44.1 kHz sampling/16 bit)
DTS*
DTS bitstream (1 – 5.1 ch)
(The analog portion is not out-
put.)
MPEG 2 LPCM (48 kHz/16 bit)
General
Power Supply : 12 V DC (11 V – 16 V) test
voltage 14.4 V, negative ground
Current Consumption : Less than 2.0 A (play mode)
Dimensions (W x H x D)
DVD Changer Unit
: 231 x 73 x 168 mm
{9-1/8” x 2-7/8” x 6-5/8”}
Disc Magazine Unit : 121 x 35 x 128 mm
{4-3/4” x 1-3/8” x 5-1/16”}
Weight
DVD Changer Unit
: 1.5 kg (3 lbs, 5 oz)
Disc Magazine Unit : 0.2 kg (6 oz)
Disc Magazine Unit : VYQ3174 (included) holds 8
discs
DVD Changer Unit
Load Impedance : More than 10 k Ω
Output Voltage : 2 V rms (1 kHz, 0 dB, at max.)
Output Impedance : 600 Ω
Channel : 2 channels
Frequency Response : 5 – 20,000 Hz ±1 dB
Signal to Noise Ratio : 95 dB
Total Harmonic Distortion : 0.006 % (1,000 Hz)
Wow and Flutter : Below measurable limit
Light Source : Semiconductor laser
Wavelength : 650 nm
Video section
Video Output : Video composite signal, 1,0 V
[p-p], 75 Ω
Note:
¡Above specifications comply with EIA standards.
¡Specifications and the design are subject to modification
without notice due to improvements in technology.
¡Some figures and illustrations on this manual may be dif-
ferent from real ones.
Specifications
*DTS only works with optical outputs.
Electrical Connection
(Continued)
Connection with Overhead Monitor (CY-VH9300U)
Connection with CD/Receiver with CD/DVD changer control and the overhead monitor (option, CQ-C9901/C9801U,
CY-VH9300U).
Note: Refer to the operating instructions for the connected devices, in addition.
DVD Changer
CX-DH801U
ACC
BATTERY 5A
PARKING BRAKE
H A
M4X5mmMAX
B C
V
H.A
H
C V.A.B
V
B
C
VIDEO CONT
VTR1-IN
VTR OUT
VIDEO-CNT
REMOTE-OUT
FRONT SP
CH/AUX2-IN REAR SP
REMOTE-IN
Extension Cord u
(BRAKE/VIDEO-C0NT/ACC/BATT/DIN/RCA/GND)
To a clean, bare metallic part of the car chassis
To the car battery, continuous + 12 V DC.
(Black)
(Red)
(Yellow)
Parking Brake Lead
(Blue/yellow stripe)
Be sure to wire the parking
brake for safety and preventing
accident.
Video control Lead (output)
(Green/yellow stripe)
(R) (Red)
(L) (White)
Front
speaker
leads
Fuse 5 A
CY-VH9300U
(option)
Not used.
(Green/yellow stripe)
Audio Output (L) (White)
Audio Output (R) (Red)
Video Output (Yellow)
(L) (White)
Video (Yellow)
(R) (Red)
Remote-In (Black)
RCA Cable
(option)
DIN Cable (Black)
To the changer
connector
CQ-C9901U
(option)
(R) (Red) (L) (White)
Rear
speaker
leads
Front speakers
(option)
Rear speakers
(option)
Electrical Connection, Specifications
MPEG 1 LPCM (48 kHz/16 bit)
Not used. Do not connect the Power Lead
(ACC) if the control unit is equipped.
Ground Lead
Power Lead
Battery Lead
Note: Never use both
Remote-Ins (one is
mini-pin jack, the other
is RCA jack) at the same
time. Failure to observe
this may cause misoper-
ation.
RCA Cable
(option)
Copyright © 2005 Matsushita Electric Industrial Co., Ltd. All right reserved.
Remote-In
(RCA) (Black)