Panasonic CX-DH801U - Manual (Page 26)

51
CX-DH801U
24
English
50
CX-DH801U
23
English
Troubleshooting
(Continued)
■
Remote Control
■
Sound Settings
■
Display Setting
The video format of the DVD changer does not correspond to the video format
of the monitor display.
a Make the video format of the DVD changer correspond to the video for-
mat of the monitor display.
The display screen is
not stable and/or col-
ored, or rotates
improperly.
The speaker leads are connected in reverse between right and left.
a Connect the speaker wires to the correct one.
Left and right sounds
are reversed.
Cables are not correctly connected.
a Connect the cables correctly.
No sound from left,
right, front, or rear
speaker.
Battery poles (+) (–) are reversed.
a Insert the battery correctly.
Wrong battery.
a Check the battery.
Battery has run down.
a Replace the battery.
Remote control is in the wrong direction.
a Direct the remote control at remote control sensor on the display unit.
Direct sunlight disturbs the transmission of remote control.
a Move your car to prevent the car from being exposed to direct sunlight, or
install the remote control sensor on another place to keep it out of direct
sunlight.
Buttons are invalid for
operation.
Tr
oubleshooting
Error Display Messages
■ DVD Changer (Control unit / Monitor display)
Problem Possible cause a Possible solution
No magazine is in the changer.
a Load the changer with disc-loaded magazine.
NO MAGAZINE
No disc is in the changer.
a Insert disc into the disc tray.
NO DISC
An attempt was made to play a disc with a region number other than “1” or
“ALL”. Or, the unknown error related with discs occurs.
a Check the disc.
- E 6 -
(Control unit display)
(REGION ERROR etc.)
(Next disc will be selected
automatically after 5 seconds.)
No operation by some cause.
a Once turn the ACC switch off, and turn it on again. And, push the reset
switch (
a page 53). If these operations fail, call the store where you pur-
chased the unit or the nearest Panasonic Servicenter.
- E 3 -
(Control unit display)
(Next disc will be selected
automatically after 5 seconds.)
Disc has scratches.
a Check the disc.
- E 2 -
(Control unit display)
(Next disc will be selected
automatically after 5 seconds.)
Disc is dirty, or is upside down.
a Check the disc.
- E 1 -
(Control unit display)
(Next disc will be selected
automatically after 5 seconds.)
Note: There may be cases when the disc numbers affected by an error are displayed before E1 and E2.