Lantronix WiSpan User Manual
Page 34
WiSpan User Guide
34
8
8
:
:
M
M
o
o
n
n
i
i
t
t
o
o
r
r
M
M
o
o
d
d
e
e
Monitor Mode is a command-line interface used for diagnostic purposes. There are two
ways to enter Monitor Mode: locally by means of the setup port or remotely by means of
the wired network.
Entering Monitor Mode via the Setup Port
To enter Monitor Mode locally:
1. Follow the same steps used for setting the serial configuration parameters.
(See
4: Quick Start
.)
2. Instead of typing three x keys, however:
a) Type
zzz to enter Monitor Mode with network connections.
b) Type
yyy to enter Monitor Mode without network connections.
A 0> prompt indicates that you have successfully entered Monitor Mode.
Entering Monitor Mode via the Network Port
To enter Monitor Mode using a Telnet connection:
1. Establish a Telnet session to the configuration port (9999). The following message
displays:
** Lantronix WiSpan Device Server ***
MAC address 00204A89468C
Software version V6.5.0.2T4 <070221>
Press Enter for Setup Mode
2.
Type
M (upper case).
A 0> prompt indicates that you have successfully entered Monitor Mode.