Loading transparencies, Loading iron-on transfers, Loading custom-size paper – Lexmark 4800 Series User Manual
Page 43: Loading banner paper

Loading transparencies
You can load up to 50 transparencies at a time.
1
Load transparencies with the rough side facing you. If the transparencies have a removable strip, each strip
should face away from you and down toward the printer.
2
Make sure:
•
The transparencies are loaded in the center of the paper support.
•
The paper guides rest against the edges of the transparencies.
Notes:
•
Transparencies with paper backing sheets are not recommended.
•
Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid
ink smudging.
Loading iron-on transfers
You can load up to 10 iron-on transfers at once, but you will achieve best results loading them one at a time.
1
Load iron-on transfers with the print side of the transfer facing you.
2
Make sure:
•
You follow the loading instructions that came with the iron-on transfers.
•
The transfers are loaded in the center of the paper support.
•
The paper guides rest against the edges of the transfers.
Loading custom-size paper
You can load up to 100 sheets of custom-size paper at a time.
1
Load paper with the print side facing you.
2
Make sure:
•
The paper size fits within these dimensions:
Width:
–
76.0–216.0 mm
–
3.0–8.5 inches
Length:
–
127.0–432.0 mm
–
5.0–17.0 inches
•
The stack height does not exceed 10 mm.
•
The paper is loaded in the center of the paper support.
•
The paper guides rest against the edges of the paper.
Loading banner paper
You can load up to 20 sheets of banner paper at a time.
1
Remove all paper from the paper support before loading the banner paper.
2
Tear off only the number of pages needed to print the banner.
43