Land Rover DEFENDER LT77S - Manual (Page 24)

MANUALGEARBOX DEFENDER
3. Fit first-second synchromesh hub, fork groove 8. Fit first gear bush.
4. Fit circlip. 10. Fit circlip.
uppermost. 9. Fit dummy bearing.
M
First-second synchromesh assembly
T3 2 57M
Fit first gear inner and outer baulk ring.
Fit cone.
7. Fit spacer.
11. Check clearance between dummy bearing and
bush. Not to exceed
12. Remove circlip, dummy bearing and bush.
9
8
7
ST3
I I
Selective first gear bush
Part number Thickness
30,955131,005
31,005131,055
31 , 1 05/31 ,155
Check first gear to bush end-float.
1. Fit roller bearing and bush to first gear.
2. Place bush flange side downwards on a raised
block on a flat surface.
NOTE: the block should be approximately
the same diameter as the bush flange so
that the gear is suspended and does not
rest on the flat surface.