Autounlock feature, Locks and security – Lincoln MKT User Manual
Page 153
6. To enable/disable the autolock feature, press the unlock control, then
press the lock control. The horn will chirp once if autolock was
deactivated or twice (one short and one long chirp) if autolock was
activated.
7. Turn the ignition off. The horn will chirp once to confirm the
procedure is complete.
Keyless entry keypad autolock enable/disable procedure
1. Turn the ignition off.
2. Close all the doors.
3. Enter factory–set 5–digit entry
code.
4. Press and hold the 3
• 4. While
holding the 3
• 4 press the 7 • 8.
5. Release the 7
• 8.
6. Release the 3
• 4.
The user will receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
Autounlock feature
The autounlock feature will unlock all the doors when:
• the ignition is on, all the doors are closed, and the vehicle has been in
motion at a speed greater than 12 mph (20 km/h);
• the vehicle has then come to a stop and the ignition is turned off or to
accessory; and
• the driver door is opened within 10 minutes of the ignition being
turned off or to accessory.
Note: The doors will not autounlock if the vehicle has been
electronically locked before the driver door is opened.
Locks and Security
153
2010 MKT (mkt)
Owners Guide, 1st Printing
USA (fus)