Lincoln MKT - Manual (Page 138)

Operating the HomeLink ா Wireless Control System
To operate, simply press and release
the appropriate HomeLink
௡ button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink
௡ at www.homelink.com or
1–800–355–3515.
Erasing HomeLink ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.
Reprogramming a single HomeLink ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
௡ button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
௡ button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
Driver Controls
138
2010 MKT (mkt)
Owners Guide, 1st Printing
USA (fus)