beautypg.com

Gas connections – Lochinvar 1 User Manual

Page 37

background image

37

Installation & Operation Manual

ƽ WARNING

Do not check for gas leaks with an open
flame -- use the bubble test. Failure to
use the bubble test or check for gas leaks
can cause severe personal injury, death, or
substantial property damage.

14. Turn on the gas supply at the manual gas valve.

15. Turn the power switch to the “ON” position.

16. Adjust the temperature set point on the control panel of

the SMART TOUCH control module to the desired

water temperature so the appliance will call for heat.

17. Check burner performance by cycling the system while

you observe burner response. The burner should ignite

promptly. Flame pattern should be stable. Turn system

off and allow burner to cool, then cycle burner again to

ensure proper ignition and flame characteristics.

Gas Pressure

The gas pressure must remain between 4 inches w.c.
(.99 kPa) minimum (5 inches w.c. for 1.0 models) and
14 inches w.c. (3.5 kPa) maximum for Natural gas and
between 8 inches w.c. (1.9 kPa) minimum and 14 inches
w.c. (3.5 kPa) maximum for LP gas during standby
(static) mode and while in operating (dynamic) mode.
If an in-line regulator is used, it must be a minimum of
10 feet (3 m) from the SYNC boiler. It is very important
that the gas line is properly purged by the gas supplier or
utility company. Failure to properly purge the lines or
improper line sizing, will result in ignition failure.

The problem is especially noticeable in NEW LP
installations and also in empty tank situations. This can
also occur when a utility company shuts off service to an
area to provide maintenance to their lines.

Gas valve replacement

The gas valve MUST NOT be replaced with a
conventional gas valve under any circumstances. As
an additional safety feature, this gas valve has a flanged
connection to the venturi and blower.

Figure 6-3 Inlet Gas Supply Check

DO NOT adjust or attempt to
measure gas valve outlet pressure.

Attempting to alter or measure the
gas valve outlet pressure could result
in damage to the valve, causing
potential severe personal injury,
death, or substantial property
damage.

Failure to follow all precautions
could result in fire, explosion, or
death!

ƽ WARNING

ƽ WARNING

6

Gas connections

(continued)