Lathem Dukane 24A715 - Manual (Page 37)

Programming Commands
To access the master clock’s programming functions, press [#] to enter program mode.
When SELECT FUNCTION CODE appears on the display, the clock is ready for
programming. The master clock will automatically exit out of program mode if you have
not made a key pad entry for five minutes.
[0]=PASSWORD
A password is required for most programming functions. To enter either the administra-
tive or user password, press [#][0][#], followed by the six-digit password, then press [#].
You can now program the master clock until the password expires. A password expires
after approximately five minutes. If the master clock starts blocking access to program-
ming functions, re-enter the password.
The administrative password 332537 [DEALER] enables you to access both user and ad-
vanced functions.
The default user password 000000 is used to access user functions. Use the
[C]=CHANGE PASSWORD function to change your user password (see page 3-6). You
cannot change the administrative password.
[1]=SET DATE / TIME
To set the date and time, see Setting the Date and Time on page 2-3.
[2]=SELECT CLOCK CTL
This function requires the administrative password. Use this function to choose the clock
types that the master clock will synchronize.
See Choosing the Clock Types to Synchronize on page 2-5.
24A715/24A715M Master Clock Installation Manual 3-3