Lathem Dukane 24A715 - Manual (Page 30)

Manually Activating Bell Controls
Use the [3]=MANUAL BELL CTRL function to test the bell circuits.
This function does not require a password. Follow the key sequences below:
Press Display
[#] SELECT FUNCTION CODE
[3] [3]=MANUAL BELL CTRL
[#] MANUAL BELL CONTROLS
1-2-3-4-5-6-7-8
PRESS AND HOLD [#]
TO EXECUTE. [*] TO END
[1]...[8] Enter the circuit numbers to be tested, then press and hold [#]. Those
circuits will turn on their relays, as shown by the green panel lights,
and the bells connected to the activated circuits will sound. When you
release the [#], the circuits will turn off their relays. Either choose and
test other circuits, or press [*] to quit.
Note:
Only circuits configured as bell zones will appear. Circuits 5–8 will
not appear if the master clock has been programmed to use these
relays for control of secondary clocks.
[*] Return to time and date display (clock mode).
2-6 24A715/24A715M Master Clock Installation Manual