Lincoln Electric POWER FEED SVM185-A - Manual (Page 11)

INSTALLATION A-3 A-3
POWER FEED® 25M
Retur
n
to
Section
T
OC
Retur
n
to
Section
T
OC
Retur
n
to
Section
T
OC
Retur
n
to
Section
T
OC
Retur
n
to
Master
T
OC
Retur
n
to
Master
T
OC
Retur
n
to
Master
T
OC
Retur
n
to
Master
T
OC
SAFETY PRECAUTIONS
ELECTRIC SHOCK CAN KILL.
• Turn the input power OFF at the
welding power source before
installation or changing drive rolls
and/or guides.
• Do not touch electrically live parts.
• When inching with the gun trigger,
electrode and drive mechanism are
"hot" to work and ground and
could remain energized several
seconds after the gun trigger is
released.
• Welding power source must be connected to
system ground per the National Electrical Code
or any applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
------------------------------------------------------------------------
LOCATION
For best wire feeding performance, place the POWER
FEED® 25M on a stable and dry surface. Keep the
wire feeder in a vertical position. Do not operate the
wire feeder on an angled surface of more than 15
degrees.
Do not submerge the POWER FEED® 25M.
The POWER FEED® 25M is rated IP23 and is suitable
for outdoor use.
The handle of the POWER FEED® 25M is intended
for moving the wire feeder about the work place only.
When suspending a wire feeder, insulate the hanging
device from the wire feeder enclosure.
HIGH FREQUENCY PROTECTION
Locate the POWER FEED® 25M away from radio con-
trolled machinery. The normal operation of the
POWER FEED® 25M may adversely affect the opera-
tion of RF controlled equipment, which may result in
bodily injury or damage to the equipment.
--------------------------------------------------------------------------
WARNING
CAUTION