Lexmark 2600 SERIES 4433 - Manual (Page 23)

Load up to Make sure
10 envelopes • The print side of the envelopes faces you.
• The stamp location is in the upper left corner.
• The envelopes are designed for use with inkjet printers.
• The envelopes are loaded in the center of the paper support.
• The paper guides rest against the edges of the envelopes.
Warning—Potential Damage: Do not use envelopes that have metal clasps,
string ties, or metal folding bars.
Notes:
– Do not load envelopes with holes, perforations, cutouts, or deep
embossing.
– Do not use envelopes that have exposed flap adhesive.
– Envelopes require more drying time. Remove each envelope as it exits,
and then allow it to dry to avoid ink smudging.
25 sheets of labels • The print side of the label sheets faces you.
• The top of the label sheets feeds into the printer first.
• The adhesive on the labels does not extend to within 1 mm of the edge
of the label sheets.
• You use full label sheets. Partial sheets (with areas exposed by missing
labels) may cause labels to peel off during printing, resulting in a paper
jam.
• The label sheets are loaded in the center of the paper support.
• The paper guides rest against the edges of the label sheets.
Note: Labels require more drying time. Remove each sheet of labels as it exits,
and then allow it to dry to avoid ink smudging.
50 transparencies • The rough side of the transparencies faces you.
• If the transparencies have a removable strip, each strip faces away from
you and down toward the printer.
• The transparencies are loaded in the center of the paper support.
• The paper guides rest against the edges of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each transparency as
it exits, and then allow it to dry to avoid ink smudging.
Loading paper and original documents
23