Linksys Etherfast - Manual (Page 8)

EtherFast ® Managed 24-Port with Dual Gigabit Switch
11
EtherFast ® Series
10
Telnet Management
Telnet management is available after the Switch has been configured with a
valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the
console interface. Use telnet from any computer attached to the network.
SNMP/RMON Management
SNMP/RMON management is available after the Switch has been configured
with a valid IP address, subnet mask, and default gateway (for Layer 2 mode)
via the console interface. Manage the Switch from any network computer
using network management software.
N No otte e:: The Switch’s configuration program only provides
access to basic configuration functions. To access the
full range of SNMP management functions, you must use
SNMP-based network management software.
4. When the following screen appears, make sure that the Switch’s serial port
settings are as follows:
BAUD RATE: 19200
DATA BITS:
8
PARITY:
None
STOP BITS:
1
FLOW CONTROL:
None
Click the OK button.
Web Management
Web management is available after the Switch has been configured with a
valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the
console interface. Use a standard Web browser (Internet Explorer 4.0 or
above, or Netscape Navigator 4.0 or above is suggested) from any computer
attached to the network. The Switch has a default IP address of 192.168.1.254
and a default subnet address of 255.255.255.0.