Linksys Etherfast User Manual

Page 12

EtherFast

Managed 24-Port with Dual Gigabit Switch

EtherFast

Series

IP Configuration

The IP Configuration menu allows you to configure the IP parameters.
(Only displayed in Layer 2 mode)

• Interface Type - Indicates IP over Ethernet.

• IP Address - IP address of the Switch you are managing. The system

supports SNMP over UDP/IP transport protocol. In this environment, all
systems on the Internet, such as network interconnection devices, must
have an IP address.

• Subnet Mask - Subnet mask of the Switch. This mask identifies the host

address bits used for routing to specific subnets.

• Gateway IP - Gateway used to pass trap messages from the system to

the management station. Note: The gateway must be defined (when oper-
ating at Layer 2) if the management station is located in a different IP
segment.

• IP State - Specifics whether IP functionality is enabled via manual con-

figuration (default setting), or set by Boot Protocol (BOOTP).

Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.

Network Configuration

The Network Configuration menu allows you to set the Switch’s IP address,
configure the IP parameters, or enable the on-board Web management.

• IP Configuration* - Sets the bootup option or configure the Switch’s IP

parameters.

• IP Connectivity Test (Ping) - Tests IP connectivity to a specified device.

• HTTP Configuration - Allows the admin to enable or disable the Web

administration.

* This menu does not appear if the Switch is set to multilayer mode. In this
case, you need to configure an IP interface for each VLAN that needs to con-
nect to any device outside of its own VLAN group.

Select OK to return to the previous panel.