Linksys Etherfast User Manual

Page 31

EtherFast

Managed 24-Port with Dual Gigabit Switch

Static Route Table

The Static Route Table screen is used to configure a static route.

• Destination Network - A destination network, subnet, or host.

• Destination Mask - The subnet mask that specifies the bits to match.

A routing entry will be used for a packet if the bits in the address set by

the destination mask match the destination network.

• VLAN - The VLAN within which the gateway or destination address

resides.

• Next Hop - The IP address of the router at the next hop.

• Type - The IP route type for the destination network.

Direct - A directly connected subnetwork
Indirect - A remote IP subnetwork or host address
Myself - A switch IP address on a specific IP subnetwork
Bcast - A subnetwork broadcast address
Mcast - An IP multicast address
Invalid - An illegal IP address to be filtered

Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the
next page. To display a specific page, set the page number in the Page field
and then press Apply. Select Add to add a routing entry.

EtherFast

Series

Add Static ARP Entry

The Add Static ARP Entry screen is used to add a static ARP entry.

• IP Address - IP address statically mapped to a physical MAC

address.

• MAC Address - MAC address statically mapped to the correspon-

ding IP address.

• Interface - The index number of the IP interface that will use

this static ARP entry. (Port “0” refers to the CPU.)

Select OK to return to the previous panel. Select Cancel to cancel any
changes.