Linksys RVS4000 - Manual (Page 31)

Chapter Setting Up and Configuring the Router
4-Port Gigabit Security Router with VPN
Administration > Diagnostics
Administration > Diagnostics
Ping Test Parameters
Ping Target IP Enter the IP address or URL that you want
to ping.
Ping Size Enter the size of the packet you want to use.
Number of Pings Enter the number of times you wish to
ping the target device.
Ping Interval Enter the time period (milliseconds)
between each ping.
Ping Timeout Enter the desired time period (milliseconds).
If a response is not received within the defined ping
period, the ping is considered to have failed.
Start Test Click this button to begin the test. A new screen
will appear and display the test results.
Ping Result Displays the Ping status.
Traceroute Test Parameters
Traceroute Target Enter the target IP address for the
traceroute test.
Start Test Click this button to begin the test. A new screen
will appear and display the test results.
Cable Diagnostics
Port Select the port number from the drop-down menu.
Pair Identifies a specific pair (A, B, C, or D) in the cable.
Each cable consists of 8 pins (4 pairs).
Cable Length Displays the length of the cable in meters.
Status Displays the status of the pair.
Administration > Backup & Restore
Administration > Backup & Restore
To download a copy of the current configuration and store
the file on your PC, click Backup to start the download.
Restore Configuration
To restore a previously saved config file back to the Router,
enter the file name in the field or click Browse to select the
config file, then click Restore to upload the config file.
Administration > Factory Default
Administration > Factory Default
Restore Factory Defaults Click this button to reset all
configuration settings to their factory default values. Any
settings that have been saved will be lost when the default
settings are restored. After clicking the button, another
screen will appear. Click OK to continue. Another screen
will appear while the system reboots.
Administration > Reboot
Administration > Reboot
Reboot Click this button to reboot the Router. This operation
will not cause the Router to lose any of its stored settings.