Lincoln Electric RANGER IM511-D - Manual (Page 36)

1 2 - 1 6 - 9 3
M 1 7 2 1 4
ELECTRODE CABLE
TO WORK ELECTRODE
14 PIN
AMPHENOL
TO WORK
TO WIRE FEED UNIT
CAUTION :
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
THE ENGINE WELDER OPERATING MANUAL.
N.B. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE OPERATING MANUAL.
N.A. USE POLARITY SWITCH TO SET FOR DESIRED ELECTRODE POLARITY. POSITION THE OUTPUT SELECTOR SWITCH TO A CV POSITION.
N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE OUTPUT CONTROL SWITCH IN "OUTPUT CONTROL REMOTE" POSITIION.
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
PLACE WELDER TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.
N.D. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
RANGER 9 / LN-25 WITH 42 VOLT REMOTE OUTPUT
CONTROL MODULE CONNECTION DIAGRAM
K626-XX INPUT CABLE ASSEMBLY
TO LN-25 INPUT
CABLE PLUG
WARNING
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
– 34 –
4-19-96D
S20909
WARNING
can kill
ELECTRIC SHOCK
- +
POWER SOURCE
6-PIN
PLUG
ELECTRODE LEAD
WORK SENSE LEAD
*
*
BYPASS
CAPACITOR
KIT
*
HI-FREQ KIT
INPUT POWER
*
5-PIN
PLUG
K915-1
AMPTROL
ADAPTER
6-SOCKET
RECEPTACLE
K963 HAND
AMPTROL
K870 FOOT
AMPTROL
OR
*
KIT FOR CONNECTION INFORMATION.
SEE INSTRUCTIONS INCLUDED WITH HI-FREQ
THIS ADAPTER ALLOWS AN AMPTROL TO OPERATE A
OUTPUT CURRENT OF A LINCOLN POWER SOURCE.
(THE POWER SOURCE MUST BE EQUIPPED WITH A
6-PIN REMOTE CONTROL AMPHENOL CONNECTOR.)
SEE THE HI-FREQ KIT AND POWER SOURCE INSTRUC-
AND CONTROL SETTINGS.
TION MANUAL FOR INFORMATION ON PROPER SWITCH
OF THE WELDING POWER SOURCE "OFF"
TURN THE ENGINE OR POWER SWITCH
BEFORE CONNECTING OR DISCONNECTING
PLUGS TO WELDING POWER SOURCE.
K915-1 AMPTROL ADAPTER FOR K799 HI-FREQ KITS
K799 HI-FREQ KIT WHILE REMOTELY CONTROLLING THE
K799 HI-FREQ KIT