Kenwood DPX-MP6110U - Manual (Page 27)

English | 27
Connecting Wires to Terminals
P.CONT
ILLUMI
ANT.
CONT
MUTE
REMO.CONT
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse
(10A)
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
Motor antenna control wire (Blue)
TEL mute wire (Brown) Connect to the terminal that is grounded when either the telephone rings
or during conversation.
⁄ To connect the Kenwood navigation system, consult your navigation
manual.
Power control/Motor antenna control wire
(Blue/White)
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
Dimmer control wire (Orange / White)
To car light control switch
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matches your car is
required.
Steering remote control
(Light Blue/Yellow)
Front preout
Rear/SubWoofer preout