Kenwood DPX-MP6110U User Manual
Page 19
English
|
19
Audio Preset Memory
Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Cabin selection (page 17)
- DTA (Digital Time Alignment) setting (page 17)
- X’Over setting (page 17)
- Equalizer Control (page 18)
- Preset position selection (page 18)
- Manual position setting (page 19)
2
Enter Audio Preset Memory mode
Select “SOUND”
>
“PRESET”
>
“MEMO”.
For how to select Function Control item, refer to
Audio Preset Recall
Recalling the sound setup registered by
1
Select the source
For how to select source item, refer to
4).
2
Enter Audio Preset Recall mode
Select “SOUND”
>
“PRESET”
>
“RECALL”.
For how to select Function Control item, refer to
3
Recall the Audio Preset
Press the Control knob.
“Recall?” is displayed.
4
Turn the Control knob to select “YES”, and then
press the Control knob.
“Recall Completed” is displayed.
5
Exit Audio Preset Recall mode
Press the [FNC] button.
⁄
• The User memory of “SYSTEM Q” in
(page 18) is changed to the value which was recalled.
• The source tone memory item of
(page 18) is changed to the value which was recalled by
the selected source.
Manual position setting
Making fine adjustment of the value specified at
Preset position selection per speaker.
1
Enter Position setting mode
Select “SOUND”
>
“S-CTRL”
>
“POSIT”
>
“M-POSI”.
For how to select Function Control item, refer to
2
Select the Position you want to adjust
Item
Setting overview
“Front Lch”
Front Left speaker
“Front Rch”
Front Right speaker
“Rear Lch”
Rear Left speaker
“Rear Rch”
Rear Right speaker
“Sub Lch”
Subwoofer Left
“Sub Rch”
Subwoofer Right
Turn the Control knob and push the center
when the desired item is displayed.
3
Adjust the speaker
Turn the Control knob.
Adjust between 0 and 170 cm.
4
Exit Position setting mode
Press the [FNC] button.
⁄
• When you select “User” at
(page 18), the adjusted setting value will be recalled.
3
Put the Audio Preset in the memory
Press the Control knob.
“Memory?” is displayed.
4
Turn the Control knob to select “YES”, and then
press the Control knob.
“Memory Completed” is displayed.
5
Exit Audio Preset mode
Press the [FNC] button.
⁄
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.