Kodak i1800 Series - Manual (Page 74)

A-61555 March 2007 5-9
Vacuuming the transport
area 1. Open the pod.
2. Thoroughly vacuum the entire transport area, paying particular
attention to these areas:
Vacuuming under the
background strips 1. Using the green tabs pull off the upper and lower background strips
and set them aside.
2. Vacuum the areas where the background strips are adhered to.
3. Reinstall the upper and lower background strips.
the edges of the transport the reflective tape near the
front of the transport
the reflective tape near the
front of the pod
the three multifeed sensors at the base
of the transport and the pod