Kenwood KRF-V6300D - Manual (Page 5)

English
5
HDMI ™(High-Definition Multimedia Interface)
terminal
!
Making HDMI connection let you enjoy high quality video such as
Blu-ray discs.
Audio signals came in at Audio IN termianl are interlocked with
Video signals output at the HDMI MONITOR OUT terminal.
High-quality music playback in Pure Audio Mode
•
This function reproduces music signals in high quality with high
fidelity to original sound.
In this mode, the display and the analog video circuitry are
turned off to eliminate their effects on the audio circuitry. In
addition, the optimum listen mode is selected according to the
input music signal.
True home theater sound ª
This unit incorporates a wide variety of surround modes to bring
you maximum enjoyment from your video software. Select a
surround mode according to your equipment or the software you
are going to play and enjoy!
• Dolby Digital
• Dolby Digital EX
• Dolby Pro Logic II
• Dolby Pro Logic IIx
• DTS Digital Surround
• DTS-ES
• DTS Neo:6
• DTS 96/24
Easy Setup of the speaker ¡
The speaker settings can be completed by simply selecting the
room type and the listening position. The audio will be corrected
automatically according to the characteristics of the speaker
system in use.
Crossover Frequency Adjustment ∞
The bass frequency from the subwoofer and the other speakers
can be adjusted making better sound phase between speakers
and natural sound field.
Audio Delay function (Lip Sync) ∞
This function corrects deviation between the video and audio.
The operating instructions given in this manual assume that the
user mainly operates the receiver using the remote control unit.
When the same operation is also available on the main unit, the
operating method is indicated in illustrations.
The [VOLUME CONTROL], [MULTI CONTROL] and [INPUT
SELECTOR] knobs on the main unit are operated by turning the
knobs clockwise or counterclockwise.
Example:
TONE
BASS BOOST
MULTI CONTROL
O/
ACTIVE EQ
MULTI CONTROL ACTIVE EQ
Adjustin e To Adjusting the Tone
¶ Operation available only on the remote control unit.
The tone level can be adjusted when the input signal is a PCM or
analog signal and the listen mode of this unit is set to "Stereo".
œ Press [TONE] to select the Tone mode.
∑ Use [MULTI CONTROL ∞/5] to select "TONE ON" or
"TONE OFF".
é When in "TONE ON" selection, press [TONE] for the
following displays.
Display Setting Range
"BASS" Adjusts low frequency range. -10 – +10 (in 2 step)
"TREB" Adjusts high frequency range. -10 – +10 (in 2 step)
® Use [MULTI CONTROL ∞/5] to adjust the sound
quality.
† Press [TONE].
• When the ACTIVE EQ mode is set to ON, set it to OFF and then
control the TONE setting.
O
Further notes, tips
and operating
restrictions are
explained.
The operating
procedures refer to
those of the remote
control unit. Some
operations are also
available using the
key (or knob) of the
same name on the
main unit.
Options to be
selected are listed
in a table.
The knob on the main
unit is pointed with an
arrow to indicate that it
can be turned in either
direction.
• The illustrations of the main unit display panel and the examples
of operations are shown for the purpose of explanation and may
differ from the actual view or operation.
Special features Notes on instructions p