Kenwood CT-403 - Manual (Page 15)

15
How to record (deck B only)
To stop recording
In stop mode During recording
Pause
To pause recording temporarily
How to provide non-recorded blanks between programs
Press successively twice.
To resume recording
Press once.
÷ After leaving a non-recorded blank of about 4 seconds, the deck enters
the record-pause mode.
2
Stop playing the source component.
1
Stop the tape transport.
Dolby noise reduction system
The Dolby noise reduction system was developed to reduce the tape hiss noise generated during playback.
The optimum effect of the Dolby NR system is obtained when the same type NR system is used for both recording and playback. If a
different type NR system is used, playback is not performed correctly. Make sure that the same type noise reduction system is used for
both recording and playback.
Dolby B NR
The most popular noise reduction system used in home audio components. Usually, Dolby NR system corresponds to B NR.
8
PAUSE
¶
REC/ARM
7
(dB) — —5 0 +3 +6 (dB)
¶
REC/ARM
¶
REC/ARM