Kenwood CT-403 - Manual (Page 14)

14
How to record (deck B only)
Since this unit is not designed for use with metal tapes,
recording on metal tapes cannot be carried out.
Insert a tape in deck B.
2
Select the source to be recorded.
Set up the cassette deck.
1
÷
Press to record with the DOLBY NR.
2 Select the recording mode.
(CT-403/KXF-W3030 only)
: Keys or controls to be used in this operation
1 Select the Dolby NR mode.
1 Dolby NR on
2 Dolby NR off
÷ Each press switches the indication.
1 “ [” :Double-side recording which stops tape after having
recorded both sides.
2 “ ”” :Recording stops after having recorded both sides.
3 “ “” :One-way recording which stops tape after having re-
corded a single side.
(dB) — —5 0 +3 +6 (dB)
(dB) — —5 0 +3 +6 (dB)
(dB) — —5 0 +3 +6 (dB)
@ # 7
1 8 PAUSE ¶ REC/ARM ¡ TAPE B
AUTO REVERSE
PUSH/OPEN 0
A
DOLBY NR
REV.MODE
Preparation
Start recording.
4
2 Enter the record-pause mode.
1 Play a music source.
3 Adjust the recording level.
1 Play the music source from the
beginning.
2 Press the ÷REC/ARM key.
Set the recording level.
3
4 Stop playing the source.
÷ Adjust so that seg-
ments around the 0 dB
segment of the peak
level meter light up at
times.
Press once.
(dB) — —5 0 +3 +6 (dB)
(dB) — —5 0 +3 +6 (dB)
REC LEVEL
MIN MAX
¶
REC/ARM
(dB) —5 0 +3 +6 (dB)
÷ While pressing the PAUSEkey,
press the REC/ARM key. ¶
REC/ARM
8
PAUSE
÷ Recording will start.
÷ The deck enters the stop mode automatically when the tape has
been recorded till the end. (CT-401/KXF-W1030)
(dB) — —5 0 +3 +6 (dB)
The figure shows an example for the CT-403 or KXF-W3030
(dB) — —5 0 +3 +6 (dB)
TAPE B
AUTO REVERSE
TAPE A
AUTO REVERSE
POWER
1
@ # 7 @ # 7
¡ 1 8 PAUSE ¶ REC/ARM ¡
PUSH/OPEN 0 PUSH/OPEN 0
DOLBY NR DOLBY NR
Lit Goes off
Dolby NR on Dolby NR off