Kenwood CT-403 - Manual (Page 10)

10
Listening to cassette tapes
Determine the playback conditions.
1
1 Select the Dolby NR mode.
2 Select the playback mode.
(CT-403/KXF-W3030 only)
÷ Set to OFF the Dolby NR key when playing a tape recorded with-
out using Dolby NR.
2
Start playback.
CT-403
/KXF-W3030
or
2 Load a cassette tape in deck A or B. (Normal playback)
Load cassette tapes in both decks. (Relay playback)
1 Set the POWER switch to ON.
Press the area marked
PUSH/OPEN
0.
1 Dolby NR on
2 Dolby NR off
: Keys or controls to be used in this operation
Normal playback
(dB) — —5 0 +3 +6 (dB)
TAPE B
AUTO REVERSE
TAPE A
AUTO REVERSE
POWER
1
@ # 7 @ # 7
¡ 1 8 PAUSE ¶ REC/ARM ¡
PUSH/OPEN 0 PUSH/OPEN 0
POWER
- ON – OFF
PUSH/OPEN 0 (dB) — —5 0 DOLBY NR
7 7
1
8 P
¡
REC L
PUSH/O PEN 0 (dB) — —5 0 DOLBY NR
7 7
1
8 ¡
REC
PUSH/O PEN 0
(dB) — —5 DOLBY NR
7 7
1 ¡
÷ Be sure to remove tape slack before insertion.
÷ The type of tape, that is, the Normal, High position or
Metal position (playback only) is selected automatically.
÷ This unit cannot record sound on a Metal tape.
÷ Be sure to close the cassette
holder securely by pushing it.
DOLBY NR
(dB) — —5 0 +3 +6 (dB)
(dB) — —5 0 +3 +6 (dB)
REV.MODE
÷ Each press switches the indication.
1 “ [” :Double-side playback which stops tape after having
played both sides.
2 “ ”” :Playback is endless.
3 “ “” :One-way playback which stops tape after having played
a single side.
@ # 7 3
CT-401
/KXF-W1030
÷ Tapes are played in the directions indicated by their
respective indicators. (CT-403/KXF-W3030)
÷ Playback stops automatically at the end of tape.
(CT-401/KXF-W1030)
The figure shows an example for the CT-403 or KXF-W3030
DOLBY NR DOLBY NR
Lit Goes off
Dolby NR on Dolby NR off
Preparation