Kenwood KDV-5234 - Manual (Page 78)

78 KDV-5234
Installation
Firewall Accessory
89
Attachment screw
Bend the tabs of the mounting sleeve with a screwdriver
or similar utensil and attach it in place.
Accessory 0
Rubber Bush
• When the space between the unit and Firewall is
narrow
• When the space between the unit and Firewall is
wide
Unit
Unit
Firewall
Accessory 0
Rubber Bush
Accessory
8
Attachment screw
Firewall
Accessory 0
Rubber Bush
Accessory
9
Attachment screw
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
Installation
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main
unit so that it does not fall off.
1 Refer to the section
rubber frame> (page 79) and then remove the
hard rubber frame.
2 Drop open the faceplate by pressing the
Release button.
3 Tighten the screw (ш2 Ч 5 mm) (Accessory
4)
and bracket (Accessory
5) in the hole shown
on the diagram.
Accessory 4
Accessory
5
4 Tighten the screw (ш2 Ч 5 mm) (Accessory
4)
and bracket (Accessory
6) in the hole shown
on the diagram.
Accessory 6
Accessory
4
• Never insert the screws in any other screw hole than the
one specified. If you screw them in another hole, it will
contact and may cause damage to the mechanical parts
inside the unit.