Kenwood KDV-5234 - Manual (Page 52)

52 KDV-5234
Menu
Setting security code
Sets a security code to prevent theft.
• Before setting a security code, turn off the demonstration
mode. For further information, refer to setup> (page 53).
• When you activate the Security Code function, it cannot
be released.
Note, your Security Code is the 4-digit number entered in
your "Car Audio Passport" in this package.
1 Set to the menu mode
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
SRC
MENU
2 Select the security code set feature
CODE SET
3 Start security code setting
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
ENTER CODE : ––––
4 Enter a security code
Select the digit to enter.
Select a number to enter.
5
Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
RE-ENTER CODE : ––––
6 Repeat the entry
Using the same method as in the step 4, enter
the same security code.
7 Confirm the entry
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
AME FM SCRL
SRC
APPROVED
8 Exit the security code setting
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
SRC
• If the security code entered in step 6 is different from the
code entered in step 4, you must repeat the procedure
from step 4.
• Once the security code has been set, the code needs to
be entered every time the reset button is pressed or the
battery is disconnected. For further information, refer to
(page 53).
• The security code can be set in the STANDBY state. For
the basic method of how to operate the menu, refer to