Kenwood KDV-5234 - Manual (Page 58)

58 KDV-5234
Remote Controller
This unit can be operated using the Remote Controller supplied with the unit.
• Put the Remote Controller in a place where it will not move during braking or other operations. A dangerous situation could
result, if the Remote Controller falls down and gets wedged under the pedals while driving.
• Do not place the battery near an open flame or heat source. This may cause the battery to explode.
• Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak
fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician.
Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a
physician.
Battery installation
Using a pen tip or similar object, open the battery
compartment in Direction
2 (as shown) while
unfastening the lock in Direction
1 (as shown).
Insert the lithium battery (CR2025) supplied,
making sure the polarities are correct. (See the
illustration inside the battery compartment.)
• If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that the
lithium battery is depleted. In such instances, replace the
battery with a new one.
Remote Controller mode switch
The functions operated from the remote
controller differ depending on the position of the
mode switch.
DVD mode
Switch to this mode when
playing DVDs or CDs etc.
with the player integrated
in this unit.
AUD mode
Switch to this mode when
controlling a selected
source or a CD changer etc.
• The position of the remote control mode switch is
indicated in the title of each mode, e.g., "(AUD mode)".
• When controlling a player that is not integrated in the
unit, select "AUD" mode.