Security code entry, Demonstration setup, English 53 – Kenwood KDV-5234 User Manual
Page 53: Enter a security code select the digit to enter, Select a number to enter, Confirm the entry, The power turns on, Demonstrates the functions of this unit, Set to the menu mode, Select the demonstration feature
English 53
Security code entry
If a security code is set, you must enter the code
the first time you turn the unit on after the reset
button has been pressed or the unit has been
disconnected to the battery of the car.
1
Enter a security code
Select the digit to enter.
Select a number to enter.
Enter the security code set in
2
Confirm the entry
Q
AM
SETUP
AUD
VOL
ATT
MENU
SCAN
STOP
M/S
RDM
REP
F.SEL
M.RDM
OFF
DISP
/PTY
SW
AME
FM
SCRL
SRC
The power turns on.
APPROVED
• If you enter wrong security code, the message
"WAITING#" (# : number of times you entered wrong
code) will be displayed, and you cannot operate the unit
for a certain period of time. Re-enter the code after the
following operation prohibition time is passed.
Number of times for entering
wrong security code
Operation prohibition
time
1st time
None
2nd time
5 minutes
3rd time
1 hour
4th time
24 hours
Demonstration setup
Demonstrates the functions of this unit.
1
Set to the menu mode
Q
AM
SETUP
AUD
VOL
MENU
SCAN
STOP
M/S
RDM
REP
F.SEL
M.RDM
OFF
DISP
/PTY
SW
SRC
MENU
2
Select the demonstration feature
DEMO
3
Set up the demonstration feature
AM
SETUP
AUD
VOL
ATT
M/S
DISP
/PTY
SW
AME
TI
FM
SCRL
DEMO OFF
The demonstration function turns ON/OFF
each time the button is pressed and held down
for 2 seconds or more.
• This setting can be used in the standby state. For the
basic method to operate the menu, refer to